 |
|||||
 |
|||||
Gallery>> Boats
36ft Runaway Royal Sportfish
Extra caution used at the waterline because hull sides had been painted with fairing and paint extending below the true waterline
35ft Island Packet
Large sections of paint releasing from the hull, visible in pic
Removed all buildup, no blisters or imperfections found
61ft Viking
Before
During
After
28ft Grover
Just repowered with a fresh diesel and the owner wanted a clean hull. Years of buildup were removed, barrier coat applied, and the boat was relaunched.
Before
After
36ft Grand Banks
Tented and partially blasted for blister repair
41ft Defever
Paint needed to be removed to expose blisters discovered during a pre-purchase survey.
60ft Sal Magundi
Aluminum Motor Yacht
Objective: Remove antifoul paint leaving primer for hull inspection and repair
55ft Californian
Removed all paint from the hull to expose blisters which varried in size (1" to 6" diameter)
40ft SeaRay
Removed all paint buildup of barrier coat application
58ft SunSeeker
Starboard transom before
Starboard transom after
Starboard bow before
Starboard bow after
Tented in boat shed during blasting
After
38ft Henriques
Removed build up to achieve smooth fuel efficient running surface
2005 30ft Shamrock
Boat appeared to be in good shape. Paint bond was failing in a few small areas. Owner wanted the boat stripped to check hulls integrity & blisters, prior to the manufacturer's warranty expiring.
31ft Custom Built Trawler
Cold molded boat with delaminated glass below the waterline. Paint was removed in order to repair the glass prior to the application of a barrier coat and antifoul paint.
30ft 2005 Rampage
Paint failure- paint was releasing from the gel coat
38ft 2005 Rampage
Paint failure: everything was removed prior to a spring application of a barrier coat and new paint.
33ft 2005 Proline
Paint failure: poor bond of initial paint application
32ft Luhrs
24ft Albemarle
Years of built up paint removed. Boat was repowered and stripped bare to resurrect a classic hull.
23ft Searay
Left in the water without paint for 3 months. First the growth had to be scraped, then the hull was blasted to remove the barnacle rings.
